2D diagram
21.5927.9421.5927.94

How to make a stunt paper airplane

Stunt Paper Airplane: try all 10 steps in the 3D player. Turn and replay every move. Print the complete diagram sheet or save it as PDF.

EasyAn Origami Tutor design10 steps8.5 × 11 in · One rectangle

An Origami Tutor stunt plane with up-turned wingtips: broad wings with a winglet standing at each end. Bend the back edges of its wings up and it loops the loop.

You need
One sheet of letter paper (A4 works too). No glue or scissors.
Start
Lay a sheet of letter paper in front of you, short edge at the top.
Tips
  • Keep both winglets upright and the same height, or the plane turns to one side.
  • Bend the back edges up a little more for tighter loops; flatten them to fly straight.
Symbols, bases & terms ↗
Finish

Your model is ready

For a loop, bend the back edges of the wings up a little and throw the plane firmly upward.

3D paper
10 steps · press any step to watch it in 3D

Step-by-step diagrams

Valley fold Mountain fold Color side White side
  1. 1

    Crease the middle

    Fold the paper in half from left to right, crease it, and open it again.

  2. 2

    Fold the left corner in

    Fold the top left corner down so the top edge lies along the center crease.

  3. 3

    Fold the right corner in

    Fold the top right corner the same way. The top is now a point.

  4. 4

    Fold in half

    Fold the plane in half along the center crease, with the corner folds on the outside.

  5. 5

    Fold the first wing down

    Fold the top wing down along a line about an inch from the body's fold and parallel to it.

  6. 6

    Fold the first wingtip

    Fold the straight end of the wing back over it, along a line about an inch in from the edge. This strip is the winglet.

  7. 7

    Fold the second wing behind

    Fold the other wing back along the same line as the first.

  8. 8

    Fold the second wingtip

    Fold the end of the back wing behind along the same line as the first winglet, so the two match.

  9. 9

    Open both winglets

    Open both narrow tip folds a quarter turn, so each strip stands at a right angle to its wing. Keep the two sides even.

  10. 10

    Open both wings

    Spread the broad wings away from the body along their creases. Leave a shallow V, with both tips a little higher than the roots and the winglets pointing upward. Then turn the plane upright, keel below.

  11. ✓

    Finish

    For a loop, bend the back edges of the wings up a little and throw the plane firmly upward.