2D diagram
12121212

How to make a heart photo frame

Heart Photo Frame (Paper): try all 4 steps in the 3D player. Turn and replay every move. Print the complete diagram sheet or save it as PDF.

EasyAn Origami Tutor design4 steps12 × 12 cm · One square

An Origami Tutor heart frame: fold a square in half, cut a small half heart for the window and a large half heart for the outline, then open a heart with a heart-shaped window for a photo.

You need
Thin paper, a pencil, a ruler and scissors.
Start
Begin with a 12 cm square of red or pink paper, colored side up. Keep an edge at the top.
Finish

Your model is ready

Smooth the centre crease. Glue a photo or a sheet of colored paper behind the window, and write a message on the border. The finished frame, with its heart-shaped window in the middle.

3D paper
4 steps · press any step to watch it in 3D

Step-by-step diagrams

  1. 1

    Fold the square in half

    Bring the left edge to the right edge. Match the corners and press the vertical fold. Keep the folded edge on the left.

  2. 2

    Cut the heart window

    Draw a small half heart against the folded edge, about a third as wide as the paper. Start on the fold at its dip, cut up and round the lobe, down the side and in to the point on the fold. Cut through both layers and throw away the little half heart.

  3. 3

    Cut the heart outline

    Draw a large half heart round it, with a wide border between the two. Start on the fold at the dip, cut round the lobe and down the side to the point on the fold. Keep the half frame beside the fold and throw away the paper round it.

  4. 4

    Open the frame

    Open the centre fold gently. The border runs round a heart-shaped window.

  5. ✓

    Finish

    Smooth the centre crease. Glue a photo or a sheet of colored paper behind the window, and write a message on the border. The finished frame, with its heart-shaped window in the middle.