2D diagram
15.2415.2415.2415.24

How to make an origami rabbit face

Origami Rabbit Face: try all 6 steps in the 3D player. Turn and replay every move. Print the complete diagram sheet or save it as PDF.

EasyAn Origami Tutor design6 steps6 × 6 in · One square

An Origami Tutor bunny face with two tall ears, folded from one square in five easy folds. A thin band along the bottom edge turns into the ears.

You need
One square of origami paper and a pen for the face. No glue or scissors.
Start
Start white side up, with one corner pointing up. Pink, white or brown paper all make a good bunny.
Tips
  • A wider band makes fatter ears; a thinner one makes slim ears.
  • Draw the face after all the folding is done.
Symbols, bases & terms ↗
Finish

Draw the rabbit’s face

Press the folds flat. Draw two dot eyes, a little nose, a smile and short whiskers on the smooth face below the ears. The finished bunny face, with its two tall ears above its smooth face.

3D paper
6 steps · press any step to watch it in 3D

Step-by-step diagrams

Valley fold Mountain fold Color side White side
  1. 1

    Make a triangle

    Fold the bottom corner up to the top corner.

  2. 2

    Fold up a thin band

    Fold the long bottom edge up a little, about as wide as your finger. This band will make the ears.

  3. 3

    Fold the top down

    Fold the top point down so it almost touches the band.

  4. 4

    Raise the left ear

    Fold the left corner up so the band stands up beside the middle as a tall ear. Let it lean out a little.

  5. 5

    Raise the right ear

    Fold the right corner up the same way, so the two ears make a narrow V.

  6. 6

    Turn over

    Turn the bunny over. Its smooth face is in front, with the ears standing up behind it.

  7. ✓

    Finish

    Press the folds flat. Draw two dot eyes, a little nose, a smile and short whiskers on the smooth face below the ears. The finished bunny face, with its two tall ears above its smooth face.